iDRY Vacuum Kilns

Sponsors:

Echo CS400 How Install Worm Gear

Started by lindylex, September 22, 2020, 10:39:17 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages1
User actions

lindylex

September 22, 2020, 10:39:17 PM
I successfully remove the worm gear and would like to know how to press it back on?  I did not purchase Echo's specialty tool for removal.  I built my own to remove it.  

Hilltop366

#1
September 23, 2020, 10:38:09 AM
Guessing oil pump drive?

I'm not sure of Echo's prescribed method but if the crank shaft is cold and the gear is very warm it may fall right on.

lindylex

#2
September 24, 2020, 08:11:17 PM
Thanks for the response.  If I can find some kind of hardware that is threaded on the inside and on the outside.  I can thread it on to the shaft and then screw something that will clear the shaft around what is screwed on and push/press the worm gear down.

ladylake

#3
September 25, 2020, 10:26:19 AM


  I'd try some ice around the crank and heating the worm gear first.  Steve
Timberking B20  18000  hours +  Case75xt grapple + forks+8" snow bucket + dirt bucket   770 Oliver   Lots(too many) of chainsaws, Like the Echo saws and the Stihl and Husky     W5  Case loader   1  trailers  Wright sharpener     Suffolk  setter Volvo MCT125c skid loader
Print
Go Up Pages1
User actions

Thank You Sponsors!