The Forestry Forum
General Forestry => Sawmills and Milling => Topic started by: Peter Drouin on April 22, 2016, 06:05:25 AM
I have tried with 1" and 2" with mix results. When John bumps them, it's not good.
(https://forestryforum.com/gallery/albums/userpics/22511/SAM_0565.JPG)
(https://forestryforum.com/gallery/albums/userpics/22511/SAM_0567.JPG)
16d will pull out. So I'm going to try ¼x4" lags and 4x4.
(https://forestryforum.com/gallery/albums/userpics/22511/SAM_0563.JPG)
(https://forestryforum.com/gallery/albums/userpics/22511/SAM_0564.JPG)
(https://forestryforum.com/gallery/albums/userpics/22511/SAM_0568.JPG)
I left out the bottom 2x to give more room.. Will see if this will work better.
Also had to replace a cable on John for the clutch to work, all good now.
(https://forestryforum.com/gallery/albums/userpics/22511/SAM_0566.JPG)
Maybe you need a smaller John. ;D I know,a smaller John would not lift as much.
I know hardwood cost more,but would it hold up better. Too bad you don't have a bunch of metal kicking around. Than John would stop breaking,and start bending. ;D
Peter
Try the GRK screws and lags they hold great and can be drivin with a cordless drill .
Bruno
+2 on the GRK RSS lags.
I think the GRK is 2x the money
Cfarm, I have a pile of 6' fence post. ;)