The Forestry Forum is sponsored in part by:

iDRY Vacuum Kilns

Forestry Forum
Sponsored by:

TimberKing Sawmills

Toll Free 1-800-582-0470

LogRite Tools

Norwood Industries Inc.

Your source for Portable Sawmills, Edgers, Resaws, Sharpeners, Setters, Bandsaw Blades and Sawmill Parts

EZ Boardwalk Sawmills. More Saw For Less Money! sponsored by Northeast STIHL

Woodland Sawmills

Peterson Swingmills

 KASCO SharpTech WoodMaxx Blades


Sawmill Exchange

Michigan Firewood, your BRUTE FORCE Authorized Dealer

Baker Products


iDRY Wood Lumber Vacuum Drying for everyon

Nyle Kiln Dry Systems

Chainsawr, The Worlds Largest Inventory of Chainsaw Parts

Smith Sawmill Service

Author Topic: Conventional Kiln Controller  (Read 931 times)

0 Members and 1 Guest are viewing this topic.

Offline Ga_Boy

  • Senior Member x2
  • *****
  • Posts: 1014
  • Age: 59
  • Location: Purlear, NC
  • Gender: Male
  • Been rode hard and hung up wet; more than once.
    • Share Post
Conventional Kiln Controller
« on: August 13, 2012, 07:05:09 AM »
Kiln controller with relative humidity sensor and temperture probe.  This unit senses chamber heat and humidity levels then sends a signal to adjust humidity and/or temperture to pre set level.  The controller has a 7 day chart recorder.  Is gives you a perment record of the humidity and temerture conditions in the kiln during each dry cycle.

Commercially produced unit, manufacture is still in business (located in PA).  Will include hard copies of USDA kiln dry publications.

$1,800 plus shipping.
10 Acers in the Blue Ridge Mountains

Share via delicious Share via digg Share via facebook Share via linkedin Share via pinterest Share via reddit Share via stumble Share via tumblr Share via twitter

Conventional kiln?

Started by DanG on Sawmills and Milling

7 Replies
Last post November 01, 2003, 10:40:26 AM
by Den Socling
Conventional Kiln Components

Started by Ga_Boy on For Sale

5 Replies
Last post March 30, 2015, 01:39:07 PM
by Ga_Boy
Conventional kiln heating

Started by Cruiser_79 on Drying and Processing

5 Replies
Last post July 17, 2021, 10:37:25 AM
by GeneWengert-WoodDoc
Conventional kiln venting

Started by Hokiemill on Drying and Processing

3 Replies
Last post June 21, 2004, 07:56:43 PM
by Don_Lewis

Powered by EzPortal