Print Page - ID Needed for Woodmizer Roller

Title: ID Needed for Woodmizer Roller
Post by: quadracutter222 on January 25, 2019, 08:47:37 PM

Hi all, hoping some Woodmizer savvy guys can weigh in. I am looking at these as replacements for the plastic pressure pads on my mill and wondering if some WoodMizer guys know a few details.

I am wondering what the roller is made of, and how much adjustability is possible in what is shown in the picture only. If the vertical plate is mounted to the mill, how much adjustability is left? Vertical and Horizontal or just tip front to back? Also, I assume the roller is metal?

I can get these locally and for less than the Cooks, but perhaps not a good option if adjustability is limited.

Thanks!

<
br>(https://forestryforum.com/gallery/albums/userpics/51095/20190125_155310.jpg?easyrotate_cache=1548466908)

Title: Re: ID Needed for Woodmizer Roller
Post by: donbj on January 25, 2019, 09:25:01 PM

That's not a wood mizer set up

Title: Re: ID Needed for Woodmizer Roller
Post by: Woodpecker52 on January 26, 2019, 12:54:50 AM

This is wat woodmizers blade guide rollers look like.
(https://forestryforum.com/gallery/albums/userpics/51812/IMG_0738.JPG?easyrotate_cache=1548344905)

(https://forestryforum.com/gallery/albums/userpics/51812/IMG_0735.JPG?easyrotate_cache=1548344858)

(https://forestryforum.com/gallery/albums/userpics/51812/IMG_0665.JPG?easyrotate_cache=1548286378)

(https://forestryforum.com/gallery/albums/userpics/51812/IMG_0734.JPG?easyrotate_cache=1548344791)

The Forestry Forum

General Forestry => Sawmills and Milling => Topic started by: quadracutter222 on January 25, 2019, 08:47:37 PM