The Forestry Forum
General Forestry => Sawmills and Milling => Topic started by: sawwood on March 28, 2019, 08:29:16 PM
I needed a new blade roller on our mark 4 Norwood and i had a spare one. When i went
to install it i notice the bolt that holds it is smaller then the inside of the bearing. I looked
in the parts listing and the bolt is a 5/8 size. I took the bearing to tractor supply and a 5/8
bolt is also loose in the bearing. I looked at a 16mm and it was loose and a 18mm was to
big. On your guys roller is the bolt that holds it small to or does it fit the size of the beaning?
Sawwood