The Forestry Forum
General Forestry => Chainsaws => Topic started by: Gearbox on September 06, 2020, 09:20:54 PM
Does anyone have a cure for the worn pin that lets the brake engage without bumping the handle . I have cleaned it and it is some better . I blow it out with air often but now it is getting worse . This 372 I run on the processer so I can tie the handle back but I would like to fix it .
I found the breakdown on Partstree, parts are readily available.
From the little I can find the wear is in the case and there may be a oversized pin to drill out and install . I just need to figure out a part # or who makes it . I will look on Parts Tree