The Forestry Forum
General Forestry => Firewood and Wood Heating => Topic started by: Logging logginglogging on November 30, 2012, 11:01:29 AM
Has any one with a 2300 on here had a LED controller malfucntion? what were the symptoms? Was it dificult to replace the sencor that it connects to.
When i checked it this am, the stove read 190 (much higher than it normally goes) I opened the door of only a second glanced over and saw it read 189. (OK no big deal a normal 1 degree drop). I threw in a couple pieces, and closed the door withing just a minute or so. when I closed the door the stove read 179, and then proceded to kick on the blower and run like it normally does when it reaches 179.
Has anyone experienced anything like this?
I think i was just tired ...it was early AM. I have seen no problems or anything like this before or after.