The Forestry Forum
General Forestry => General Board => Topic started by: Jailson on December 10, 2014, 09:42:09 AM
i am trying to get a 1987????? (Around that year). It has been sitting quite a while. Is there a primer and where would it be
It is a Cat D4B dozer
should be near the injection pump. black plastic knob. turn it to the left to unlock it then push up an down
If it won't start after priming check to see if theres water in the fuel.
After you address the fuel system make certain the Battery bank is topped off and spinning the motor over
at a good clip.
Let us know how you make out,
Best
DGDrls
+1 to all the above.
Good luck! 8)