Have a client that wants to slab a pecan that is roughly 60" and about 4-5' long, was a blow over but intact. Located in Eatonton GA. My LT15 will not handle it.
http://www.billsmill.com/ Has slabber and will travel. Try contacting Bill, he is FF member, Nomad.
I believe FF member Gasawyer has a slabbing mill and isn't too far from Eatonton. Send him a PM.
Quote from: Ga Mtn Man on November 09, 2016, 04:23:21 PM
I believe FF member Gasawyer has a slabbing mill and isn't too far from Eatonton. Send him a PM.
Maybe they will invite me to come watch.
Me too.
Thanks guys, I sent GAsawyer a message. It would be nice to get a little crowd together and "watch" him work. There are also a couple of great eating places in Eatonton, my treat!
new to saw milling my self it would be good to find other people in georgia to learn from.
Quote from: sandpig on November 17, 2016, 07:51:57 PM
new to saw milling my self it would be good to find other people in georgia to learn from.
Where are you located @sandpig?
If that does not work out, I can travel to Ga with the Lucas, but it cost $2 a mile, one way.
Quote from: willmyers0169 on November 18, 2016, 03:52:39 AM
Quote from: sandpig on November 17, 2016, 07:51:57 PM
new to saw milling my self it would be good to find other people in georgia to learn from.
Where are you located @sandpig?
Hey sorry I didn't see this I haven't had much time to get online. I am in North East Ga near Commerce
Sandpig you need to come to the project at customsawyers this year. It is the super bowl of sawyers hanging out down east.