The Forestry Forum

General Forestry => Sawmills and Milling => Topic started by: peterob on January 18, 2014, 09:05:44 PM

Title: oil
Post by: peterob on January 18, 2014, 09:05:44 PM
just a question what is everyone running for oil i have a 25hp  kohler  on a lt28  thanks peter

Title: Re: oil
Post by: dgdrls on January 18, 2014, 10:59:44 PM
I run Full synthetic Castrol  in My Kohler 27 & Napa Filters
Check the Kohler site for weight requirement and spec/rating if you don't have your book(s)

DGDrls
Title: Re: oil
Post by: Chuck White on January 19, 2014, 07:12:11 AM
I use 15W40!

Seems to work well, I also shut down when the weather starts to turn cold and start up again in the Spring!
Title: Re: oil
Post by: bandmiller2 on January 19, 2014, 07:50:35 AM
Once A new engine is broken in on dino oil theirs no reason not to go synthetic, on this sized engine cost is a little factor. Aircooled engines run hot and the extra protection, not to mention cold starts, makes it worthwile. A little 2cyc. synthetic mix added to the gas will help the valves and the engine top end. Good engine management will extend the life of your engine. Frank C.
Title: Re: oil
Post by: Bill Gaiche on January 19, 2014, 09:16:06 AM
10w-30 wal mart synthetic. Use this in all my engines except diesels. bg
Title: Re: oil
Post by: Dewey on January 19, 2014, 09:42:47 AM
I run Mobil One 10-30 Napa Filter I have over 6500 hrs on this motor