L53 aluminum kiln chamber parts list/assembly

[kps4str]

Looking for parts list/assembly instructions to show someone and can't find in the 2 file cabinets I inherited. 

Thanks.

[K-Guy]

This link is for the L53 manual and the chamber plans are in there also.

https://www.nyledrykilns.com/wp-content/uploads/2023/10/NDK-L53-Manual-Rev-2023.02.pdf

[kps4str]

Thanks, yes, I have that, but we want to make the aluminum chamber. The manual gives wood/stick built chamber. Wall thickness for aluminum/insulation, etc. At least want to compare cost, including time. Came across a company doing a KilnTainer from refer shipping container and have not heard back from the contact I was given at Nyle for a cost on that. Since the kiln will be set up at a potentially temporary location it would be easier with a KilnTainer or aluminum changer vs stick built to move later.

[K-Guy]

Aluminum will be expensive that is why we stopped offering an aluminum chamber for the L53. As far as a shipping container goes a 20' container is too big and the L53 will have trouble heating it. Our chamber specs limit the length tp 13' and that can take a while to heat up without extra heat depending on where you are.