Nut size

[JustinW_NZ]

Hi all

Quick question
woodmizer lt40super, what is the nut size on the roller bearings holding the mill head on the rails?

I cant find the spanner I used to use for that job and have the mill 4 hours drive from me currently so thought I better go get a new spanner before I install the new bearing.

A link to a parts manual would do the trick too as I'm sure its in there too (my book is down with the mill)

Thanks in advance
Justin

[drobertson]

1-1/8" on mine

[JustinW_NZ]

1-1/8" on mine

Thanks for that, I will go to the store tomorrow before I leave and get one - Since we are metric around here I don't have lots of imperial sized spanners lying about!

Cheers
Justin

[terrifictimbersllc]

I'm trying to remember what a spanner is.  :D

[Magicman]

I recently encountered this with a piece of equipment built across the Atlantic.  The owners manual kept referring to a "spanner" and I finally realized that they were talking about a "socket".   ;D

[Kbeitz]

This is what we call a Spanner Wrench in Pa.



 

[terrifictimbersllc]

Exactly

[Ga Mtn Man]

In down-under speak, is a spanner a socket or a wrench? ???

[Dave Shepard]

I think it's a combo wrench outside the US. In the US it's what Kbeitz shows.

[customsawyer]

If you are talking about the cam follower bearings the end wrench size is 15/16

[drobertson]

If you are talking about the cam follower bearings the end wrench size is 15/16

That's right, its the upper housing plate that is 1-1/8 sorry bout that one good call sir!