Forum > Lucas Mill

cutting with lucas mill

(1/2) > >>

j78blake:
the vertical cut is not matching up with the horizontal cut anymore. it's off by a 1/6 of an inch.  :-\

starmac:
I can offer no help, but want to see the answer also, as this is something I have wondered about on these mills.

thecfarm:
Welcome to the forum.
Just guessing,got a tooth out of whack? When did this all start to happen?
I have only seen them at a show.

j78blake:
It's not the blade. Or the teeth. This has been going on since last fall. We quit milling in the winter. Enough to be aggravating.  ::)

Don P:
It's almost always the log moving, tension being released. Can you move over a little more on the horizontal cut to release it? Take a couple of light cuts that are too small to release any tension, just to "prove" whether the lines are meeting.

Navigation

[0] Message Index

[#] Next page

Go to full version
Sitemap