The Forestry Forum is sponsored in part by:

iDRY Vacuum Kilns

Forestry Forum
Sponsored by:

TimberKing Sawmills

Toll Free 1-800-582-0470

LogRite Tools

Norwood Industries Inc.

Your source for Portable Sawmills, Edgers, Resaws, Sharpeners, Setters, Bandsaw Blades and Sawmill Parts

EZ Boardwalk Sawmills. More Saw For Less Money! sponsored by Northeast STIHL

Woodland Sawmills

Peterson Swingmills

 KASCO SharpTech WoodMaxx Blades


Sawmill Exchange

Michigan Firewood, your BRUTE FORCE Authorized Dealer

Baker Products


iDRY Wood Lumber Vacuum Drying for everyon

Nyle Kiln Dry Systems

Chainsawr, The Worlds Largest Inventory of Chainsaw Parts

Smith Sawmill Service

Dynamic Green Products Inc.

Author Topic: Upgraded Engine on OS23  (Read 585 times)

0 Members and 1 Guest are viewing this topic.

Online Nebraska

  • Senior Member x2
  • *****
  • Posts: 1421
  • Age: 53
  • Location: God's country or pretty close
  • Gender: Male
  • Lurked for quite a while, learning !
    • Share Post
Re: Upgraded Engine on OS23
« Reply #20 on: January 29, 2021, 02:09:50 PM »



This will give you the jist, I looked through my gallery quick and this was what I had there. I will take a picture of them specifically after work. First shows table I can off put to, and my slab rack. Second  picture shows both and my temporary  storage rack in the background.  I use my pallet forks as an extra  table as well.  Yes I wish my mill was bigger and hydraulic, but it does work well.

Share via delicious Share via digg Share via facebook Share via linkedin Share via pinterest Share via reddit Share via stumble Share via tumblr Share via twitter

I upgraded!

Started by Dan_Shade on Sawmills and Milling

24 Replies
Last post October 19, 2006, 10:38:50 PM
by SawDust_Studios
Upgraded My Truck

Started by SawyerTed on General Board

23 Replies
Last post January 01, 2019, 08:21:24 PM
by SawyerTed
Upgraded Peterson

Started by maple flats on Sawmills and Milling

1 Replies
Last post November 11, 2019, 12:09:52 PM
by El Oso
Upgraded the LT15

Started by JP135 on Sawmills and Milling

9 Replies
Last post May 11, 2015, 02:31:36 PM
by kng

Powered by EzPortal