The Forestry Forum is sponsored in part by:

iDRY Vacuum Kilns


Forestry Forum
Sponsored by:


TimberKing Sawmills



Toll Free 1-800-582-0470

LogRite Tools



Norwood Industries Inc.




Your source for Portable Sawmills, Edgers, Resaws, Sharpeners, Setters, Bandsaw Blades and Sawmill Parts

EZ Boardwalk Sawmills. More Saw For Less Money!

STIHLDealers.com sponsored by Northeast STIHL


Woodland Sawmills

Peterson Swingmills

KASCO SharpTech WoodMaxx Blades

Turbosawmill

Sawmill Exchange

Michigan Firewood, your BRUTE FORCE Authorized Dealer

Baker Products

ECHO-Bearcat

iDRY Wood Lumber Vacuum Drying for everyon

Nyle Kiln Dry Systems

Chainsawr, The Worlds Largest Inventory of Chainsaw Parts

Smith Sawmill Service

Dynamic Green Products Inc.





« previous next »
Pages: 1 [2]  All   Go Down

Author Topic: Still not cutting SQUARE!?!?!  (Read 1422 times)

0 Members and 1 Guest are viewing this topic.

Offline quadracutter222

  • Full Member
  • **
  • Posts: 98
  • Location: British Columbia
  • Gender: Male
  • D&L 10/20, Kubota XD23, Long 5n1, MS461
    • Share Post
Re: Still not cutting SQUARE!?!?!
« Reply #20 on: January 31, 2019, 10:40:27 PM »
These are the guides, to pad only.

Logged
Pages: 1 [2]  All   Go Up
« previous next »

* Share Topic

Share via delicious Share via digg Share via facebook Share via linkedin Share via pinterest Share via reddit Share via stumble Share via tumblr Share via twitter

* Similar Topics

xx
cutting log ends to square

Started by michaelvp on Timber Framing/Log construction

20 Replies
25559 Views 		Last post September 17, 2009, 02:06:48 PM
by Doug_D
xx
Need some ideas for square cutting 6x6's

Started by Redhorseshoe on Sawmills and Milling

14 Replies
728 Views 		Last post November 30, 2020, 01:30:16 PM
by Larry
xx
Cutting square with LT28

Started by jrkimroxie on Sawmills and Milling

30 Replies
13324 Views 		Last post January 09, 2011, 11:54:34 PM
by MartyParsons
xx
Cutting a square hole in a board

Started by Osric on General Woodworking

10 Replies
11545 Views 		Last post September 10, 2007, 05:53:05 PM
by metalspinner
 

Powered by EzPortal