Woodmizer EG100

[General007]

Hey everyone Im currently running a Timberking b-20 mill and I'm looking to help out and make my day a little easier with an edger.  I'm looking at a new woodmizer eg100 w/gas powerplant setup and was wondering if anyone had any experience with one or not.  I like that its a dual blade edger but can also be used as a rip saw.  My operation isnt big enough to warrant the next size up and the eg50 woodmizer offers seems a little to small for what im looking to do.  As I said I've never owned an edger or seen one in operation other than the few on youtube just looking for some insight.   

[DARRELL1972]

I have that edger and like it over all. I primarily cut pallet stock so my edger stays at the same cut width all the time. I think that if I were cutting random width boards all the time I wouldn't like it. The adjustment for the width requires you to walk around to where the motor is mounted to adjust width of cut. 

[General007]

Yeah my plan is to mostly only cut 1" siding boards and trim boards so it'll mostly be staying one size.  and I wanted the ability to take the first few boards that come off the mill and turn them into something easier than trying to edge on the mill.