The Forestry Forum is sponsored in part by:

iDRY Vacuum Kilns

Forestry Forum
Sponsored by:

TimberKing Sawmills

Toll Free 1-800-582-0470

LogRite Tools

Norwood Industries Inc.

Your source for Portable Sawmills, Edgers, Resaws, Sharpeners, Setters, Bandsaw Blades and Sawmill Parts

EZ Boardwalk Sawmills. More Saw For Less Money! sponsored by Northeast STIHL

Woodland Sawmills

Peterson Swingmills

 KASCO SharpTech WoodMaxx Blades


Sawmill Exchange

Michigan Firewood, your BRUTE FORCE Authorized Dealer


Baker Products


iDRY Wood Lumber Vacuum Drying for everyon

Nyle Kiln Dry Systems

Author Topic: Router sled...  (Read 2320 times)

0 Members and 1 Guest are viewing this topic.

Online Crusarius

  • Senior Member x2
  • *****
  • Posts: 2914
  • Age: 42
  • Location: Canadice, New York
  • Gender: Male
  • Lost in....
    • Share Post
Re: Router sled...
« Reply #20 on: May 02, 2019, 01:09:06 PM »
my router leaves a much better finish than my mill. By much, I mean yugo vs ferrari.

Offline busenitzcww

  • Full Member
  • **
  • Posts: 68
  • Age: 28
  • Location: Whitewater Ks
  • Gender: Male
  • I'm new!
    • Share Post
Re: Router sled...
« Reply #21 on: May 03, 2019, 08:38:17 AM »
I figure if they fit on the mill why not just take a skim cut to flatten it out? Then just sand and finish as usual no further  flattening is required?
I have no experience as far as milling, but I guess Id want to take as light as cut as possible but stillget it flat, which seems like it could be dicey. Like trying to cut veneer on a mill? Just seems like it could be challenging on a super wide slab.

Share via delicious Share via digg Share via facebook Share via linkedin Share via pinterest Share via reddit Share via stumble Share via tumblr Share via twitter

Router Sled

Started by 123maxbars on General Woodworking

14 Replies
Last post March 15, 2017, 12:33:54 PM
by Darrel
Router sled

Started by xlogger on General Woodworking

4 Replies
Last post September 12, 2016, 04:20:58 PM
by OffGrid973
router sled

Started by xlogger on Drying and Processing

9 Replies
Last post April 02, 2017, 10:02:33 PM
by Briankinley2004
Router Sled

Started by Bill Gaiche on General Woodworking

12 Replies
Last post February 04, 2017, 07:45:37 PM
by OffGrid973

Powered by EzPortal