The Forestry Forum is sponsored in part by:

iDRY Vacuum Kilns

Forestry Forum
Sponsored by:

TimberKing Sawmills

Toll Free 1-800-582-0470

LogRite Tools

Norwood Industries Inc.

Your source for Portable Sawmills, Edgers, Resaws, Sharpeners, Setters, Bandsaw Blades and Sawmill Parts

EZ Boardwalk Sawmills. More Saw For Less Money! sponsored by Northeast STIHL

Woodland Sawmills

Peterson Swingmills

 KASCO SharpTech WoodMaxx Blades


Sawmill Exchange

Michigan Firewood, your BRUTE FORCE Authorized Dealer

Baker Products


iDRY Wood Lumber Vacuum Drying for everyon

Nyle Kiln Dry Systems

Chainsawr, The Worlds Largest Inventory of Chainsaw Parts

Smith Sawmill Service

Dynamic Green Products Inc.

Author Topic: Problem with the Wide Head Turbo 7 Blade  (Read 981 times)

0 Members and 1 Guest are viewing this topic.

Offline moodnacreek

  • Senior Member x2
  • *****
  • Posts: 2134
  • Location: Orange County NY
  • Gender: Male
  • Sawin by the notches
    • Share Post
Re: Problem with the Wide Head Turbo 7 Blade
« Reply #20 on: September 27, 2019, 08:13:35 PM »
Yeah, right, thought the problem was in N.H.   Eastern red cedar and frozen hemlock knots will chip carbide teeth, just an example of how these two share a sawing problem.  If you are sawing with chipped tooth corners [and heating the bands and cracking them] I would think you would not be able to saw straight enough to do this.

Offline millwright

  • Senior Member
  • ****
  • Posts: 570
  • Age: 67
  • Location: northern Wisconsin
    • Share Post
Re: Problem with the Wide Head Turbo 7 Blade
« Reply #21 on: September 28, 2019, 03:36:40 PM »
I am surprised to see some of you only get 2-3 sharpenings , if I dont get at least 8 or more it is unusual . I am using a WM cbn wheel on a homemade sharpener and set every other time. 

Share via delicious Share via digg Share via facebook Share via linkedin Share via pinterest Share via reddit Share via stumble Share via tumblr Share via twitter

LT40 mill problem, chattering blade in wide cuts

Started by Kelvin on Sawmills and Milling

22 Replies
Last post March 07, 2009, 09:34:34 AM
by pineywoods
Turbo 747 Blade Question

Started by Tarheel on Sawmills and Milling

5 Replies
Last post December 13, 2019, 01:38:50 PM
by Tarheel
Somebody said you had a Wide head.......

Started by POSTON WIDEHEAD on Sawmills and Milling

78 Replies
Last post March 25, 2019, 07:07:09 PM
by Percy
LT70 wide head DCS Electric

Started by Cypress Man on Sawmills and Milling

23 Replies
Last post January 05, 2014, 06:48:54 PM
by JFarmer

Powered by EzPortal