The Forestry Forum is sponsored in part by:

iDRY Vacuum Kilns

Forestry Forum
Sponsored by:

TimberKing Sawmills

Toll Free 1-800-582-0470

LogRite Tools

Norwood Industries Inc.

Your source for Portable Sawmills, Edgers, Resaws, Sharpeners, Setters, Bandsaw Blades and Sawmill Parts

EZ Boardwalk Sawmills. More Saw For Less Money! sponsored by Northeast STIHL

Woodland Sawmills

Peterson Swingmills

 KASCO SharpTech WoodMaxx Blades


Sawmill Exchange

Michigan Firewood, your BRUTE FORCE Authorized Dealer

Baker Products


iDRY Wood Lumber Vacuum Drying for everyon

Nyle Kiln Dry Systems

Chainsawr, The Worlds Largest Inventory of Chainsaw Parts

Smith Sawmill Service

Dynamic Green Products Inc.

Author Topic: Outdoor slab labeling  (Read 1552 times)

0 Members and 1 Guest are viewing this topic.

Offline hstaples

  • Member*
  • *
  • Posts: 1
  • I'm new!
    • Share Post
Re: Outdoor slab labeling
« Reply #20 on: April 05, 2020, 08:48:00 AM »
Hi all, 
Just joining the forum ... on the verge of getting a hobby-sized mill, with the Woodland Mills 126 as the leading contender. So far, I have only cut enough chainsaw slabs that I mentally remember them all by where they're stacked. Ha!

That being said, I have used TerraSlate for outdoor garden signage. I run through a laser printer; they're waterproof and have lasted 2-3 years out in the elements. I'm assuming they'll last longer for stapling into board ends and being out of rain/sun. I haven't had to buy lately, but I got mine from Amazon. I think it's limited to laser printers only; not inkjets. 

Share via delicious Share via digg Share via facebook Share via linkedin Share via pinterest Share via reddit Share via stumble Share via tumblr Share via twitter

Inventory / labeling information, and tracking software / hardware

Started by Harry George on Urban and Community Forestry

2 Replies
Last post March 31, 2013, 11:57:51 AM
by WIwoodworker
Empyre Outdoor wood stove /Any outdoor boiler

Started by KamHillbilly on Firewood and Wood Heating

2 Replies
Last post March 30, 2018, 07:01:53 AM
by ButchC
typical slab thickness, and practical slab lengths?

Started by forrestM on Sawmills and Milling

17 Replies
Last post December 30, 2018, 11:06:00 AM
by Bruno of NH
making a 5" slab into a 3" slab

Started by spencerhenry on Sawmills and Milling

27 Replies
Last post July 29, 2011, 09:18:53 PM
by Warren

Powered by EzPortal