The Forestry Forum is sponsored in part by:

iDRY Vacuum Kilns

Forestry Forum
Sponsored by:

TimberKing Sawmills

Toll Free 1-800-582-0470

LogRite Tools

Norwood Industries Inc.

Your source for Portable Sawmills, Edgers, Resaws, Sharpeners, Setters, Bandsaw Blades and Sawmill Parts

EZ Boardwalk Sawmills. More Saw For Less Money! sponsored by Northeast STIHL

Woodland Sawmills

Peterson Swingmills

 KASCO SharpTech WoodMaxx Blades


Sawmill Exchange

Michigan Firewood, your BRUTE FORCE Authorized Dealer

Baker Products


iDRY Wood Lumber Vacuum Drying for everyon

Nyle Kiln Dry Systems

Chainsawr, The Worlds Largest Inventory of Chainsaw Parts

Smith Sawmill Service

Author Topic: Swapping from cooks to Wood Mizer, should I?  (Read 1114 times)

0 Members and 1 Guest are viewing this topic.

Offline Stephen1

  • Senior Member x2
  • *****
  • Posts: 2013
  • Age: 64
  • Location: Kilworthy ON> Canada
  • Gender: Male
  • Where there is a will, there is a way!
    • Share Post
    • muskoka Sawmill
Re: Swapping from cooks to Wood Mizer, should I?
« Reply #20 on: September 16, 2020, 03:48:00 PM »
I agree with YH. Fully Automatic.  If you are doing any quantity of blades, it's worth the upgrade to Auto. 
I now sharpen and then set with the CBN wheel.
IDRY Vacum Kiln, LT40HDWide, BMS250 sharpener/setter 742b Bobcat, TCM forklift, Sthil 026,038, 461. 1952 TEA Fergusan Tractor

Share via delicious Share via digg Share via facebook Share via linkedin Share via pinterest Share via reddit Share via stumble Share via tumblr Share via twitter


Started by LPitt on Sawmills and Milling

19 Replies
Last post March 28, 2011, 11:54:41 PM
by Handy Andy
Guides cooks or Wood mizer?

Started by Kwill on Sawmills and Milling

5 Replies
Last post March 03, 2018, 09:25:45 PM
by Kwill
Lathe-Mizer - Writing article for The Wood-Mizer Way and need input

Started by bcornelius79 on Sawmills and Milling

0 Replies
Last post February 08, 2011, 02:59:24 PM
by bcornelius79
Swapping can be fun.

Started by Jeff on General Board

15 Replies
Last post April 10, 2006, 02:29:40 AM
by iain

Powered by EzPortal