The Forestry Forum is sponsored in part by:

iDRY Vacuum Kilns

Forestry Forum
Sponsored by:

TimberKing Sawmills

Toll Free 1-800-582-0470

LogRite Tools

Norwood Industries Inc.

Your source for Portable Sawmills, Edgers, Resaws, Sharpeners, Setters, Bandsaw Blades and Sawmill Parts

EZ Boardwalk Sawmills. More Saw For Less Money! sponsored by Northeast STIHL

Woodland Sawmills

Peterson Swingmills

 KASCO SharpTech WoodMaxx Blades


Sawmill Exchange

Michigan Firewood, your BRUTE FORCE Authorized Dealer

Baker Products


iDRY Wood Lumber Vacuum Drying for everyon

Nyle Kiln Dry Systems

Chainsawr, The Worlds Largest Inventory of Chainsaw Parts

Smith Sawmill Service

Dynamic Green Products Inc.

Author Topic: Another thread with blade questions  (Read 640 times)

0 Members and 1 Guest are viewing this topic.

Offline YellowHammer

  • Senior Member x2
  • *****
  • Posts: 5136
  • Age: 55
  • Location: New Market, Alabama
  • Gender: Male
  • Take Steps to Save Steps
    • Share Post
    • Hobby Hardwood Alabama
Re: Another thread with blade questions
« Reply #20 on: September 15, 2020, 08:15:59 PM »
I agree, the 747ís were more fragile and didnít have any advantage over Turbos.

As far as a rogue tooth, itís definitive if it it directly follows your feed rate, so that the slower the feed rate, the closer the scratches are, the faster the feed rate, the further apart.  


Take steps to save steps.

If it wonít roll, its not a log; itís still a piece of tree.  Sawmills cut logs, not pieces of trees.

Kiln drying wood: When the cookies are burned, theyíre burned, and you canít fix them.  Donít burn the cookies.

Share via delicious Share via digg Share via facebook Share via linkedin Share via pinterest Share via reddit Share via stumble Share via tumblr Share via twitter

Im new to the thread. And...I have questions!

Started by coyotefur on Sawmills and Milling

46 Replies
Last post January 10, 2017, 06:26:52 AM
by ozarkgem
(2 questions in one thread) Blades & Deflection HF Sawmill

Started by Kingmt on Sawmills and Milling

26 Replies
Last post September 25, 2015, 08:47:59 PM
by Kingmt
Blade questions

Started by Michaeljp86 on Sawmills and Milling

5 Replies
Last post May 04, 2006, 06:45:19 AM
by WkndCutter
Lots of blade questions

Started by woodman58 on Sawmills and Milling

19 Replies
Last post October 12, 2016, 10:11:02 AM
by pineywoods

Powered by EzPortal