iDRY Vacuum Kilns

Sponsors:

Wind

Started by Rhodemont, March 11, 2024, 07:14:18 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Rhodemont

I have never liked sawing when temps are below freezing.  Now wind is on the list also.  With all the recent rain I was itchy to get a beam or two sawed.  The wind had dropped down from the powerful gusts last night.  I roughed the mud to get some logs in que and started getting the mill set up. The wind picked up again before I took the cover off.  I turned around and the head was sailing down the rail faster than I saw.  Wind became steady out of the north west with gusts up into the 30's.  This was kinda good because it was blowing the sawdust away from me into the woods but created all kinds of other issues that were not fun.
Woodmizer LT35HD, EG 100 Edger, JD4720 with Norse350 winch
Stihl 362, 039, Echo CS-2511T,  CS-361P, MSA 300 C-O

thecfarm

I've had the head try to sail away from me a few times too.  
:uhoh:
I now just put the hold down clamp in front of one side.
Model 6020-20hp Manual Thomas bandsaw,TC40A 4wd 40 hp New Holland tractor, 450 Norse Winch, Heatmor 400 OWB,YCC 1978-79

KenMac

I find the wind more annoying than rain, but I am stationary under a pole barn. Wind from south, west, or northwest will send me elsewhere quicky.
Cook's AC3667t, Cat Claw sharpener, Dual tooth setter, and Band Roller, Kubota B26 TLB, Takeuchi TB260C

Ianab

The swing mill has the advantage that you can spin the sawhead around and work from the other end if it's windy enough to be a problem. So, within reason I'd prefer the wind to rain. Not so bad if you have a roof to work under, but if you are mobile, it gets nasty.  
Weekend warrior, Peterson JP test pilot, Dolmar 7900 and Stihl MS310 saws and  the usual collection of power tools :)

Thank You Sponsors!