The Forestry Forum is sponsored in part by:

iDRY Vacuum Kilns


Forestry Forum
Sponsored by:


TimberKing Sawmills



Toll Free 1-800-582-0470

LogRite Tools



Norwood Industries Inc.




Your source for Portable Sawmills, Edgers, Resaws, Sharpeners, Setters, Bandsaw Blades and Sawmill Parts

EZ Boardwalk Sawmills. More Saw For Less Money!

STIHLDealers.com sponsored by Northeast STIHL


Woodland Sawmills

Peterson Swingmills

 KASCO SharpTech WoodMaxx Blades

Turbosawmill

Sawmill Exchange

Michigan Firewood, your BRUTE FORCE Authorized Dealer

Baker Products

ECHO-Bearcat

iDRY Wood Lumber Vacuum Drying for everyon

Nyle Kiln Dry Systems

Chainsawr, The Worlds Largest Inventory of Chainsaw Parts

Smith Sawmill Service





Author Topic: DIY dehumidifer Kiln - Probes, sensors and monitors  (Read 214 times)

0 Members and 1 Guest are viewing this topic.

Online Marshall7199

  • member
  • *
  • Posts: 28
  • Age: 57
  • Location: Dayton, OH
  • Gender: Male
  • I'm new!
    • Share Post
DIY dehumidifer Kiln - Probes, sensors and monitors
« on: March 16, 2020, 09:39:03 PM »
After a bit too much lurking, I am struggling to find references to safe and dependable temperature and humidity sensors / controller...Ö and at a small scale kiln operation DIY price.  

I am designing a dehumidifier kiln to be used in my shed.  Initial design is a 14 ft x 4 ft x 4 ft (ish) kiln.  Plan to run a dehumidifier kiln after air drying slabs.  Ideally I would lime it to be self controlled in that the heat or dehumidifier activate automatic based on the environment in the kiln. 

Temp controllers seem plentiful and economical.  As for humidity and a moisture sensor, open to suggestions or what others are using.

As a bonus, would be nice to have some type of a WIFI setup so I could read the info from the house.  

Recommendations are welcome
Rookie learning from the masters.


Share via delicious Share via digg Share via facebook Share via linkedin Share via pinterest Share via reddit Share via stumble Share via tumblr Share via twitter

xx
What type of sensors needed inside kiln?

Started by flip on Drying and Processing

5 Replies
2136 Views
Last post December 15, 2005, 09:47:29 AM
by flip
xx
Sensors

Started by POSTON WIDEHEAD on Sawmills and Milling

13 Replies
1524 Views
Last post November 08, 2011, 07:06:18 PM
by rbarshaw
xx
RH sensors

Started by Den Socling on Drying and Processing

9 Replies
1991 Views
Last post May 20, 2004, 05:42:19 AM
by Den Socling
xx
Proximity sensors

Started by cypresskayaksllc on Sawmills and Milling

4 Replies
1128 Views
Last post March 22, 2011, 08:01:22 PM
by cypresskayaksllc
 


Powered by EzPortal