iDRY Vacuum Kilns

Sponsors:

Replacement gas can vent cap?

Started by DR Buck, January 10, 2009, 03:22:08 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages 1 2 All
User actions

Magicman

#25
May 03, 2011, 06:22:38 PM
Welcome fishindude644, to the Forestry Forum.   :)
Knothole Sawmill, LLC     '98 Wood-Mizer LT40SuperHydraulic   WM Million BF Club Member   WM Pro Sawyer Network

It's Weird being the Same Age as Old People

Never allow your "need" to make money to exceed your "desire" to provide quality service.....The Magicman

Brad_bb

#26
May 03, 2011, 10:52:21 PM
DR_BUCK,
I had the same issue.  I had 4 out of 5 Blitz brand 5 gallon gas jugs where the vent cap had broken off and had been lost.  So I got the can model number off of the jugs, then found their website and contacted them to find out how to buy replacement vent caps.  They asked how many I needed, my address, and said they'll be in the mail free of charge.  A few days later I got them.  Awesome.  It was a poor design as the plastic loop would fatigue and break eventually.  I'm happy that they'll supply free replacements.
Anything someone can design, I can sure figure out how to fix!
If I say it\\\\\\\'s going to take so long, multiply that by at least 3!
Print
Go Up Pages 1 2 All
User actions

Thank You Sponsors!