The Forestry Forum is sponsored in part by:

iDRY Vacuum Kilns

Forestry Forum
Sponsored by:

TimberKing Sawmills

Toll Free 1-800-582-0470

LogRite Tools

Norwood Industries Inc.

Your source for Portable Sawmills, Edgers, Resaws, Sharpeners, Setters, Bandsaw Blades and Sawmill Parts

EZ Boardwalk Sawmills. More Saw For Less Money! sponsored by Northeast STIHL

Woodland Sawmills

Peterson Swingmills

 KASCO SharpTech WoodMaxx Blades


Sawmill Exchange

Michigan Firewood, your BRUTE FORCE Authorized Dealer

Baker Products


iDRY Wood Lumber Vacuum Drying for everyon

Nyle Kiln Dry Systems

Chainsawr, The Worlds Largest Inventory of Chainsaw Parts

Smith Sawmill Service

Dynamic Green Products Inc.

Author Topic: Deep Vertical Swing Mill Cuts in Hardwoods?  (Read 4704 times)

0 Members and 1 Guest are viewing this topic.

Offline Meadows Miller

  • Senior Member x2
  • *****
  • Posts: 3297
  • Age: 39
  • Location: Find a Job You Love & You Will Never Work Another Day In Your Life
  • Gender: Male
  • The Walkabout Sawyer
    • Share Post
Re: Deep Vertical Swing Mill Cuts in Hardwoods?
« Reply #20 on: October 16, 2010, 12:57:59 AM »

From what i have seen after having swung on both mills I reckon there's 2/3ds of Bugger all in it between the Two Mate  ;) and with anyone who sees all the little points of issue with Any Machine on a regular basis are usually Very Aggressive Operators  :o :) ??? ::)  in My opinion Mate  ;)  :D :D ;D 

It sounds like your having a hard time picking which mill would be just rite for you atm and like I say to anyone (and I ment to say in my Pm ;) ) Is  you have to pick which one you feel that you would be happy with as buying any piece of equipment comes down a personal decision at the end of the day you have to be happy with it Mate  ;) ;D ;D 8) 8)

Regards Chris
4TH Generation Timbergetter

Share via delicious Share via digg Share via facebook Share via linkedin Share via pinterest Share via reddit Share via stumble Share via tumblr Share via twitter

Lucas mill and hardwoods

Started by ksu_chainsaw on Sawmills and Milling

4 Replies
Last post April 21, 2004, 10:39:23 PM
by BW_Williams
vertical mill accesories

Started by hackberry jake on General Board

2 Replies
Last post December 08, 2015, 07:34:27 PM
by Larry
Vertical band mill

Started by bigred1951 on Sawmills and Milling

37 Replies
Last post February 02, 2019, 11:22:11 PM
by longtime lurker
vertical band mill

Started by smwwoody on Sawmills and Milling

2 Replies
Last post September 26, 2002, 09:40:29 PM
by smwwoody

Powered by EzPortal