The Forestry Forum is sponsored in part by:

iDRY Vacuum Kilns

Forestry Forum
Sponsored by:

TimberKing Sawmills

Toll Free 1-800-582-0470

LogRite Tools

Norwood Industries Inc.

Your source for Portable Sawmills, Edgers, Resaws, Sharpeners, Setters, Bandsaw Blades and Sawmill Parts

EZ Boardwalk Sawmills. More Saw For Less Money! sponsored by Northeast STIHL

Woodland Sawmills

Peterson Swingmills

 KASCO SharpTech WoodMaxx Blades


Sawmill Exchange

Michigan Firewood, your BRUTE FORCE Authorized Dealer


Baker Products


iDRY Wood Lumber Vacuum Drying for everyon

Nyle Kiln Dry Systems

Chainsawr, The Worlds Largest Inventory of Chainsaw Parts

Author Topic: blade rollers  (Read 1896 times)

0 Members and 1 Guest are viewing this topic.

Offline customsawyer

  • Senior Member x2
  • *****
  • Posts: 4859
  • Age: 51
  • Location: Rentz, Ga.
  • Gender: Male
    • Share Post
    • The Custom Sawyer
Re: blade rollers
« Reply #20 on: March 07, 2013, 10:46:27 AM »
I have done lots of checking of blades both new and used. I have found that almost all blades have at least a small amount of cupping. The more it is used the more cupping will develop. I have found that I get the best results not worrying about it till a problem arises.
Keep in mind that I am not a scientific type in any stretch of the word but my feeling is that the increase in length to the leading edge of the blade comes mostly from cutting.     
Two LT70s and to much other support equipment to mention.

Share via delicious Share via digg Share via facebook Share via linkedin Share via pinterest Share via reddit Share via stumble Share via tumblr Share via twitter

blade rollers

Started by steve phillips on Sawmills and Milling

3 Replies
Last post February 07, 2012, 08:04:31 PM
by steve phillips
blade guide rollers

Started by customsawyer on Sawmills and Milling

19 Replies
Last post October 26, 2004, 08:11:45 PM
by Furby
Hi-Performance blade guide rollers

Started by Chuck White on Sawmills and Milling

6 Replies
Last post March 23, 2010, 08:47:18 PM
by MartyParsons
TimberKing Blade Guide Rollers

Started by tazz on Sawmills and Milling

6 Replies
Last post August 04, 2012, 12:09:50 PM
by j rock

Powered by EzPortal