The Forestry Forum is sponsored in part by:

iDRY Vacuum Kilns

Forestry Forum
Sponsored by:

TimberKing Sawmills

Toll Free 1-800-582-0470

LogRite Tools

Norwood Industries Inc.

Your source for Portable Sawmills, Edgers, Resaws, Sharpeners, Setters, Bandsaw Blades and Sawmill Parts

EZ Boardwalk Sawmills. More Saw For Less Money! sponsored by Northeast STIHL

Woodland Sawmills

Peterson Swingmills

 KASCO SharpTech WoodMaxx Blades


Sawmill Exchange

Michigan Firewood, your BRUTE FORCE Authorized Dealer

Baker Products


iDRY Wood Lumber Vacuum Drying for everyon

Nyle Kiln Dry Systems

Chainsawr, The Worlds Largest Inventory of Chainsaw Parts

Smith Sawmill Service

Author Topic: cold weather insulation vs hot weather insulation  (Read 1315 times)

0 Members and 1 Guest are viewing this topic.

Offline jueston

  • Senior Member
  • ****
  • Posts: 875
  • Age: 34
  • Location: St. Paul MN
  • Gender: Male
    • Share Post
cold weather insulation vs hot weather insulation
« on: January 30, 2014, 04:10:21 PM »
i just read this article

it talks about how poly iso has a higher R-value than XPS because its tested at high temps, and when you compare XPS and Poly-Iso in cold temps they perform differently, showing that R-5 XPS out performs R-6 Poly-iso when compared in colder climates.

it is worth pointing out the research is based on computer modeling not real examples. but i thought it was a very interesting read

Offline RavensWood

  • member
  • *
  • Posts: 25
  • Age: 70
  • Location: Canada
  • Gender: Male
    • Share Post
Re: cold weather insulation vs hot weather insulation
« Reply #1 on: January 31, 2014, 08:07:24 PM »
I think that the performance characteristics of polyiso with temperature change are measured values (unlike virtually any other insulating material, it's R value drops as temperature goes down), the computer modeling was to establish how a wall structure using the material would behave. I believe that the numbers quoted (R5 XPS outperforming R6 Polyiso) were just used as an example of what might possibly occur - I don't think that they were actually a result of the study. The temperature dependence effect may be quite small in real life and it may be that polyiso just should not be used as an outer layer of insulation but would perform fine as an inner layer.
It is an interesting article that I read a short while ago and I have been reconsidering using recycled polyiso in a structure that I am building.

Share via delicious Share via digg Share via facebook Share via linkedin Share via pinterest Share via reddit Share via stumble Share via tumblr Share via twitter

Insulation ?

Started by J_T on Drying and Processing

28 Replies
Last post March 31, 2004, 05:33:07 AM
by FeltzE

Started by Raider Bill on General Board

29 Replies
Last post March 24, 2008, 03:11:26 PM
by scsmith42

Started by Larry on Drying and Processing

3 Replies
Last post March 08, 2021, 03:56:48 PM
by Bruno of NH
Reflective insulation

Started by okie on Alternative methods and solutions

24 Replies
Last post March 12, 2009, 02:25:03 PM
by Engineer

Powered by EzPortal