The Forestry Forum is sponsored in part by:

iDRY Vacuum Kilns


Forestry Forum
Sponsored by:


TimberKing Sawmills



Toll Free 1-800-582-0470

LogRite Tools



Norwood Industries Inc.




Your source for Portable Sawmills, Edgers, Resaws, Sharpeners, Setters, Bandsaw Blades and Sawmill Parts

EZ Boardwalk Sawmills. More Saw For Less Money!

STIHLDealers.com sponsored by Northeast STIHL


Woodland Sawmills

Peterson Swingmills

 KASCO SharpTech WoodMaxx Blades

Turbosawmill

Sawmill Exchange

Michigan Firewood, your BRUTE FORCE Authorized Dealer

FARMA


Baker Products

ECHO-Bearcat

iDRY Wood Lumber Vacuum Drying for everyon

Nyle Kiln Dry Systems






Author Topic: Strip 180  (Read 919 times)

0 Members and 1 Guest are viewing this topic.

Offline Lnewman

  • Full Member x2
  • ***
  • Posts: 117
  • Location: Marion Twp, Butler County, PA
  • Gender: Male
    • Share Post
Strip 180
« on: October 16, 2016, 11:48:22 PM »
Looking for a limbing saw to replace my froze up 211.  Any comments on the 180 would be appreciated.
Stihl 170, 210MS, 290MS, 441MS and Hudson bandsaw

Offline Lnewman

  • Full Member x2
  • ***
  • Posts: 117
  • Location: Marion Twp, Butler County, PA
  • Gender: Male
    • Share Post
Re: Strip 180
« Reply #1 on: October 16, 2016, 11:51:00 PM »
Sorry that's Steil 180 saw
Stihl 170, 210MS, 290MS, 441MS and Hudson bandsaw


Share via delicious Share via digg Share via facebook Share via linkedin Share via pinterest Share via reddit Share via stumble Share via tumblr Share via twitter

xx
Ground Strip

Started by Cazzhrdwd on Sawmills and Milling

10 Replies
1592 Views
Last post February 13, 2016, 10:29:51 AM
by Cazzhrdwd
xx
Contact strip on a WM?

Started by StorminN on Sawmills and Milling

4 Replies
1176 Views
Last post February 26, 2008, 12:33:08 PM
by StorminN
xx
nyle L53 heat strip

Started by wills swamp on Drying and Processing

7 Replies
974 Views
Last post May 02, 2016, 07:36:07 AM
by WDH
xx
Power Strip trouble

Started by stavebuyer on Sawmills and Milling

4 Replies
892 Views
Last post March 14, 2012, 10:41:08 PM
by MartyParsons
 


Powered by EzPortal