The Forestry Forum is sponsored in part by:

iDRY Vacuum Kilns

Forestry Forum
Sponsored by:

TimberKing Sawmills

Toll Free 1-800-582-0470

LogRite Tools

Norwood Industries Inc.

Your source for Portable Sawmills, Edgers, Resaws, Sharpeners, Setters, Bandsaw Blades and Sawmill Parts

EZ Boardwalk Sawmills. More Saw For Less Money! sponsored by Northeast STIHL

Woodland Sawmills

Peterson Swingmills

 KASCO SharpTech WoodMaxx Blades


Sawmill Exchange

Michigan Firewood, your BRUTE FORCE Authorized Dealer

Baker Products


iDRY Wood Lumber Vacuum Drying for everyon

Nyle Kiln Dry Systems

Chainsawr, The Worlds Largest Inventory of Chainsaw Parts

Smith Sawmill Service

Author Topic: 3 phase generator  (Read 986 times)

0 Members and 1 Guest are viewing this topic.

Online trimguy

  • Senior Member
  • ****
  • Posts: 574
  • Age: 51
  • Location: augusta ,GA
  • Gender: Male
  • I'm new!
    • Share Post
Re: 3 phase generator
« Reply #40 on: October 25, 2021, 07:51:16 PM »
Mike, Iím going to say it doesnít. Does that make it better or worse ?

I ran it a couple of times after I cleaned the rats nest out. I realize that the damage could have already been started. Maybe thatís better news, the engine could be rebuilt . I donít know if that alternator can be.When I get a chance I will Separate them and see which ones locked up. I have a lot going on, probably shouldnít have taken the time to mess with it. But, I was a little excited, just wanted to run one board through

Share via delicious Share via digg Share via facebook Share via linkedin Share via pinterest Share via reddit Share via stumble Share via tumblr Share via twitter

3 phase generator

Started by cubdriver55 on Sawmills and Milling

1 Replies
Last post October 30, 2010, 04:08:21 AM
by weisyboy
3 phase generator...Help needed

Started by Wisconsintimber on General Board

1 Replies
Last post November 10, 2016, 05:26:50 PM
by Kbeitz
3 phase 240/416 military surplus 15k generator

Started by Sedgehammer on General Board

11 Replies
Last post April 14, 2021, 11:37:55 AM
by Sedgehammer
Phase Converters (single to 3 phase)

Started by Woodslabs on General Woodworking

9 Replies
Last post November 09, 2017, 09:27:50 PM
by woodworker9

Powered by EzPortal