what type of metal is a 026 muffler made out of

[motard]

[motard]

[ladrhog]

Thanks guys a lot of good information.  I like where this post is going.  anybody have a muffler modded 026/260 they could show me.  I am tired of cleaning baked on crud off of where the 026 exhaust exits.  (stupid design in my mind) thinking about putting it right out the front. 

[motard]

You have adjustibility on that 026?

Not a Stihl guy but seem to remember some had fixed high jets?

[ladrhog]

yep have a high and low carb.  a walbro 22a I think

[Ianab]

026 is an older saw, when carbs where still fully adjustable. It's the newer models that have the "anti-tamper" screws.

Ian

[motard]

Some 026 had only a low screw (I have read)

Here is the first muffler mod I did 'bout 7 years back.



It was purty UGLY, but quite effective, since then I lean more towards silver braze than mig.

[H 2 H]

Both the 026 I have were non adjustable I change both carbs to walbro

One was a 1992 model the other 1994 model

[H 2 H]

026 MM

as pictured on the first page of this thread



Carbs Walbro