Hammer Post Bent

[Jim_Rogers]

To All:
Several years ago the TF guild made available a report about mortise and tenon joinery.
It is commonly known as "The Joint Report"
For members of the guild it is available for free download from the members only section.
For all others it can be purchased threw the guild online store at: Click here for the link to buy "The Joint Report" .
It's only $15.
I hope this is what you were looking for.
Also there is another booklet on the publications page under "Workbook, Handbooks and Reports". This could also have some of the information you are looking for.
Jim Rogers

[wadeep]

thanks Jim,

I ordered a copy sounds like that is exactly the info I was looking for. Here is a URL for a website that is an index of free structural analysis software that is available. I down loaded the 1st on the list and seems to work quite well. I checked it on some simple structures that I did by hand and they checked out OK.

Click here for link to "Free Structural Software" webpage

Wadeep

[logosoluser]

Jim, I have looked at the calculators on this site, but I have not been able to find this Don P's calculator link that you have talked about in this discussion. Can you provide a link for it or explain better where it is?

[Jim_Rogers]

On the left side of the any Forestry Forum screen is a pull down box that says:"Calculators" the link to Don P's calculators are in there.
Jim Rogers

[Don P]

Once on my index, click the link titled "Beams and Columns"
 
This should be a shortcut to that address;
https://forestryforum.com/members/donp/beamindex.html

 I downloaded some of the calculators at Wadeep's link  8) 8) 8)