iDRY Vacuum Kilns

Sponsors:

cleaning

Started by D._Frederick, September 10, 2009, 06:08:47 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages1
User actions

D._Frederick

September 10, 2009, 06:08:47 PM
The instruction manual with my 372 requires taking out screw to clean it.

If you are constantly taking screw in and out, how do you keep them tight? Do you Locktight them in?

GASoline71

#1
September 10, 2009, 07:51:23 PM
Uh... which screw?

Gary
\"...if ya mess with the bull... ya gets the horn.\"

Meadows Miller

#2
September 11, 2009, 08:10:06 AM
Quote from: GASoline71 on September 10, 2009, 07:51:23 PM
Uh... which screw?

Gary

  Gary I think he means the screws in the cover for  the pull start  Mate  ;)

Nah thats what the chainsaw spanners for  ;) :D ;D just check them every morning when your using the saw  ;) ;D 8) Also check your muffler with alanskey every so often it'll save it from rattling itself to bits too mate  ;)

Regards Chris
4TH Generation Timbergetter

GASoline71

#3
September 11, 2009, 07:49:35 PM
You guys are talkin' in hieroglyphics mang...  :D  :D

Gary
\"...if ya mess with the bull... ya gets the horn.\"

D._Frederick

#4
September 12, 2009, 10:50:46 AM
I took out the seven screws that hold the starter assembly and the cylinder cover, was surpriced to fined that metal screw inserts were in the plastic. I was thinking that the screws screw directly into plastic and taking them in and out would result in problems.
Print
Go Up Pages1
User actions

Thank You Sponsors!