The Forestry Forum is sponsored in part by:

iDRY Vacuum Kilns


Forestry Forum
Sponsored by:


TimberKing Sawmills



Toll Free 1-800-582-0470

LogRite Tools



Norwood Industries Inc.




Your source for Portable Sawmills, Edgers, Resaws, Sharpeners, Setters, Bandsaw Blades and Sawmill Parts

EZ Boardwalk Sawmills. More Saw For Less Money!

STIHLDealers.com sponsored by Northeast STIHL


Woodland Sawmills

Peterson Swingmills

 KASCO SharpTech WoodMaxx Blades

Turbosawmill

Sawmill Exchange

Michigan Firewood, your BRUTE FORCE Authorized Dealer

Baker Products

ECHO-Bearcat

iDRY Wood Lumber Vacuum Drying for everyon

Nyle Kiln Dry Systems

Chainsawr, The Worlds Largest Inventory of Chainsaw Parts

Smith Sawmill Service





Author Topic: EZ Boardwalk blade tension  (Read 107 times)

0 Members and 1 Guest are viewing this topic.

Offline hopm

  • Senior Member
  • ****
  • Posts: 278
    • Share Post
EZ Boardwalk blade tension
« on: September 13, 2020, 05:29:18 PM »
What should blade tension be set at on model 40 .042 blade? I had been watching the stop but was unsure of how much tension was actually on the band. I copied someone from the board (not sure who I need to thank) and made a fork to go on a torque wrench. I have been running about 38 lb. I checked with a second torque wrench and got the same measure. What should I go up to without worry of unnecessary strain or wear?


Share via delicious Share via digg Share via facebook Share via linkedin Share via pinterest Share via reddit Share via stumble Share via tumblr Share via twitter

xx
Blade tension

Started by MrMoo on Sawmills and Milling

7 Replies
2079 Views
Last post May 24, 2004, 08:19:41 PM
by DR_Buck
xx
Blade tension

Started by Coltbodi on Sawmills and Milling

25 Replies
2177 Views
Last post October 17, 2017, 07:54:35 PM
by Peter Drouin
xx
Tension on blade

Started by Kasba on Sawmills and Milling

20 Replies
5192 Views
Last post October 22, 2015, 08:38:07 PM
by Kingmt
xx
Blade Tension

Started by Brewzur on Sawmills and Milling

7 Replies
1852 Views
Last post July 17, 2011, 04:37:53 AM
by Log-ic
 


Powered by EzPortal