Looking for some help from you guys. I have been looking for a used Baker or Logosol for awhile. I've spoke with several knife manufacters looking for advice on the machines. I was informed that when the ph260 was introduced the upper molding head could only remove 3/8" of material. The later models where improved and they can remove 3/4" of material. That is a big upgrade that I feel I have to have. He was unsure of the year the changes were made. The model I'm looking at is approximately a 2006.
Would any of you guys know what year the change was made or how to tell?
While I'm at it, what should I look for in a used small 4 head molder? Anything to avoid? I was really leaning toward a Baker, but would settle for a Logosol.
Side Note: I'm leaning towards one of these smaller 4 head machines for two reasons. The power requirements. I only have single phase so I'm going to have to build a RPC. And the footprint. My shop isn't huge.